![]() ![]() The ‘Lasercut53′ type is a standalone version of Lasercut which can be used in demonstration mode without the need for the softdog dongle. Install Lasercut using the default settings. ![]() ![]() Run the “Setup.exe” program from within the LaserCut 5.3 folder, this will start the installation of Lasercut 5.3 In a typical install all the required drivers will be set up as part of the Lasercut Installer, the additional drivers are only provided for completeness. The driver to connect directly to the laser cutter. An additional driver for the USB dongle if you are using a 64 bit version of Windows 7 This is used to prepare the cutting files before sending them to the laser Extract the files from the zipped archive to a new directory. The Lasercut 5.3 installation files can be downloaded here. Having problems with your laser cutter or software? Try our new community forum: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |